SPCR

some early pics...I need to dismantle the whole thing again because one of the parts is defective. Probably xchanging for a new set of heatpipe. Will update with more pics soon.

back side


after i ripped the noisy little bitch off the card...


The Zalman installs fine with the ramsinks intact.

At the moment, I am running the card without tapping power from PSU...the core is running @ 250MHz, memory@500MHz. The card is cooled with a 80mm Panaflo L1A.

the front Zalman heatplate


enough clearance for stock ramsinks on the front of card


the rear ramsink plate causes the zalman's rear heatsink base to be slightly off balance.


top view


back Zalman heatplate

FINAL PRODUCT

I secured a 80mm Panaflo L1a to the card using cable ties.



The card installed...





running at 450core/900mem. Card goes up to ard 72C in 3D mode.