SPCR

Hi

My Antec Phantom 500 just died

I was wondering if the modu82+ has long enough cables for use in the antec p180 case?

Thank you for helping.

Welcome to SPCR !

I cant answer your question. Sorry.
Could you please tell me where your going to get the Modu82+ from?

I want one too but its not available in DK.

Edit: Cable legths are mentioned here

Hello,

The review of the Mini P180 used the Enermax -- it is just about 3" shorter than the P18x -- it certainly looks like there would be plenty of length!

AuraAllan wrote:Welcome to SPCR !

I cant answer your question. Sorry.
Could you please tell me where your going to get the Modu82+ from?

I want one too but its not available in DK.

Edit: Cable legths are mentioned here

HI

I am going to use www.preis.de

serpent wrote:HI

I am going to use www.preis.de

Thanks

I have the Enermax Modu82 425W in the P180 and the cable reaches everywhere I could think of except if you are in the sorry position of having a mobo with a power connector right at the very top of the board like me. I use an extender. I did turn the Enermax upside down which allowed it to reach, but it started making buzzing noises.

Incidentally, the 425W is a great power supply. Cut my AC power from 86W down to 78W, and the last PSU was a Seasonic S-12 330 80+ which is extremely efficient itself.

Fits my P182 (almost the same) just fine:

Thank you for the nice picture tutu

I just ordered the modu

hello
i have P182 too and a p5e3
your 12v on the motherboard is in top rear ? near fan ?
thanks

foufou55 wrote:hello
i have P182 too and a p5e3
your 12v on the motherboard is in top rear ? near fan ?
thanks

I assume this question is for me!! My 12v is top rear (near fan). It's a 6-pin (PSU comes with 4-pin as well).

thanks like my p5e3 ! So it's good for my p182. My old corsair hx520w it's die. It's a good psu