SPCR

Good evening.

I'm trying to configure a system with the following components:
asus motherboard z170i pro gamming
2 modules 8Gb DDR4 to 2133 Mhz 17000 Kingston HyperX Fury
1 SSD 240GB Kingston HyperX Fury
Source streacom nano 120w psu
No dedicated graphics , use the built- in plate .

Is a valid configuration?

Thank you for your attention

cnb wrote:Is a valid configuration?

If your question is "Will a Streacom Nano 120 be able to power such a rig?", the answer is "Probably yes" (but I wouldn't try to run synthetic benchmarks with a fully fledged Core i7).

my 4770K can reach 150W on picoPSU, even though skylake should be slightly better it wont be 30W better. Be careful going with 6700K, probably a 6600K or below you should be fine.

sorry , I forgot to tell my processor is an i5 6600 but also when I connect components, LED plate light , but does nothing more to turn it on.thanks, I'm very grateful to you.

cnb wrote:when I connect components, LED plate light , but does nothing more to turn it on.

Contact Streacom customer support, it might be either incompatible (with your mobo) or defective.

Thanks for all friends. Finally my new pc works perfectly with the odd scare .
Asus z170i pro gamming
Kingston HyperX 16GB DDR4 2133
240 gb ssd hyperx
i5 6600
Stracom FC8 fanless box evo
120 watt psu nano streacom

Dissipation system does not fit the plate and I had to use a hammer and patience to adjust the copper tubes .
Therefore everything ok . For those who decide to board I 've ridden better to choose one that best fitting .

I said . Thanks everyone for your help.

P.S. I hope at full capacity not exceeding 70 degrees celsius . I still have not tested in this scenario .