Page 1 of 1
MSI K8N Neo Platinum and Cool 'n Quiet
Posted: Mon Jun 14, 2004 9:07 pm
by Matt-man
Is anyone using Cool 'n Quiet successfully on this board? I'm using it with an Athlon 64 3000+. I have CnQ enabled in the BIOS, the AMD driver is loaded, and I have the power management set on Minimal. However, MSI's CoreCell utility as well as WCPUID are indicating that it's only dropping to 200x9 from the 200x10 full speed.
Any suggestions? I believe this CPU should drop down to something like 1GHz when idle.
Re: MSI K8N Neo Platinum and Cool 'n Quiet
Posted: Mon Jun 14, 2004 11:34 pm
by aidanjm2004
Matt-man wrote:Any suggestions? I believe this CPU should drop down to something like 1GHz when idle.
I'm thinking of getting an MSI Athlon board, so hopefully someone has an answer to this.
Posted: Mon Jun 21, 2004 10:33 am
by sammermpc
I'm running an MSI K8t neo-fis2r. I know pretty different, but my CnQ works fine, multiplier drops to four.
Posted: Thu Jun 24, 2004 8:26 am
by bonzichrille
hi matt-man!
As Im writing this my K8N neo platinum is reporting a speed of 1000mhz 5x mult, all I´ve done is enabled it in the bios and set power management in controlopanel to minimal. Works like a charm!
Posted: Fri Jun 25, 2004 1:07 pm
by jojo4u
bonzichrille wrote:hi matt-man!
As Im writing this my K8N neo platinum is reporting a speed of 1000mhz 5x mult, all I´ve done is enabled it in the bios and set power management in controlopanel to minimal. Works like a charm!
Cool
Just a little question: How many memory slots do you have populated?
Posted: Fri Jun 25, 2004 11:08 pm
by RLiu818
I have it enabled on my 3200+ clawhammer CG
and in the WinXP System Profile it shows it running at 1.0ghz.
Posted: Sat Jun 26, 2004 5:05 am
by dimva
sammermpc wrote:I'm running an MSI K8t neo-fis2r. I know pretty different, but my CnQ works fine, multiplier drops to four.
Same here. Cheapest 3200 ram available (Corsair value) 2x512mb. Yes, that's two slots.
I only had a single problem with dual slots: I had to change the locations of the memory from -XX to X-X or XX-.
Posted: Fri Jul 30, 2004 6:39 pm
by Matt-man
For what it's worth, I updated to the version 1.20 BIOS and now it idles at 200x5.
2 new questions
Posted: Fri Jul 30, 2004 7:24 pm
by NeilBlanchard
Hello:
Has anybody tried running all three RAM slots at DDR400? If so, what RAM and what latency settings?
Is this board undervoltable? If so, what have you managed, with what CPU?
Posted: Fri Jul 30, 2004 8:03 pm
by villa_joe
Matt-man,
I have the same board and processor, MSI K8T Neo Fisr2 & A64 3200. Cool N Quiet activated running 200*4. Everything works well.
Also undervolted to 1.392