Lian Li V1020b gtx780 prolimatech mk-26 build

[aerial]

Not exactly new hardware, except gtx780, which is high tdp card. Prolimatech mk-26, 140mm fans at 5v, quiet and very efficient.
As you can see cooler is suspended, so there is no sagging in pci-e slot, and pcb of graphic card is perfectly flat.
Case obviously isn't best choice for quiet builds, as there is this huge mesh front panel, but it provides really good ventilation.
Gpu temps in crysis 3 maxed, ~60-65c, depending on location in the game. Cpu in grass level, where load is nearly 100% all threads, maxes at around 70-72 peak.
All fans operate at minimum starting voltage, around 5 volts.
Fans used in build are Tacens Aura pro 140mm, and gelid silent for 120mm (rear panel and front cpu cooler fan, rest are 140mm)

i7 2700k @ 4.8ghz - Phanteks PH-TC14PE
gtx780 + prolimatech mk-26 + 2x140mm fans @ 500rpm
gigabyte p67a-ud5
gskill ripjawsx 2x4gb 2133 cl9
intel ssd + wd green 1tb
corsair rm750

https://picasaweb.google.com/1040301312 ... iV1020Rev2

[Abula]

Very nice build, congrats. Btw how much better temps you getting vs your FT02?

Btw what fans you using?

[aerial]

It is quite hard to compare, as I didn't use same fans setup. CPU was just 1 fan in the middle of heatsink, no exhaust 120mm fan mounted, and 2x180 intake. So cpu temps were quite bit worse, since gpu was blowing in cpu's direction, and that air was stuck there.
Another difference is, that I had 2x120mm fans installed on mk-26 when it was in ft02, so another difference.