Antec P182 Super

sniperdude · Post by **sniperdude** » Fri Jan 02, 2009 1:07 pm

just looking at the Antec P182 Super and wondering would that front door
prevent me from having a fan controller ?

wojtek · Post by **wojtek** » Fri Jan 02, 2009 2:41 pm

No - in most cases. Which you intend to use?

sniperdude · Post by **sniperdude** » Fri Jan 02, 2009 5:37 pm

Scythe Kaze Master

ugrakarma · Post by **ugrakarma** » Fri Jan 02, 2009 6:18 pm

You have around 20mm to play around with and most knobs don't protrude that much. As an example the ones in a cheap cooltek were just 10mm. And now I feel extremely dirty.

sniperdude · Post by **sniperdude** » Sat Jan 03, 2009 2:48 pm

the ones on mine are about 12mm are you totally sure i have 20mm
play ?

digitalpunk · Post by **digitalpunk** » Sat Jan 03, 2009 4:18 pm

I Just checked on my P180 which is essentially the same case. Measured 3/4 of an inch from the front 5 1/4 drive locations to the back of the door. Works out to just over 19mm. You should be fine.

Blacktales · Post by **Blacktales** » Sat Jan 03, 2009 4:36 pm

AFAIK we have yet to find a fan controller that will NOT fit in the p182 so yes you have nothing to worry about.

It was already discussed in lots of threads so try searching the forum next time :

- Scythe Kaze Master review in a p182
viewtopic.php?t=46494

- Other threads on the subject
viewtopic.php?t=50150
viewtopic.php?t=43598
viewtopic.php?t=44453
viewtopic.php?t=41579

Have fun tinkering !