Where to get U-channel tubing?

Nick Geraedts · Post by **Nick Geraedts** » Wed Feb 25, 2009 4:51 pm

I'm planning on doing some mods to my case/cases in the near future, but I was wondering if people had any suggestions on where to get the U-channel tubing to cover up the edges of cut holes.

Digikey? McMaster Carr? Local hardware store?

derekva · Post by **derekva** » Wed Feb 25, 2009 5:50 pm

Nick Geraedts wrote:I'm planning on doing some mods to my case/cases in the near future, but I was wondering if people had any suggestions on where to get the U-channel tubing to cover up the edges of cut holes.

Digikey? McMaster Carr? Local hardware store?

Try FrozenCPU. That's where I got mine.

http://www.frozencpu.com/cat/l3/g44/c11 ... Page1.html

-D

thejamppa · Post by **thejamppa** » Thu Feb 26, 2009 12:32 am

I do my own. I get free broken bike inner tubes from local bike repair shop and when I cut that inner tire, separating edges from middle with scirssors or so, I get two pieces of u-tube rubber and depending how much I cut I also get 2 straight rubbers, which can be used to dampening fans or building HDD suspensions.

baconandeggs · Post by **baconandeggs** » Thu Feb 26, 2009 1:18 am

your nearest electrical supplies shop. they call it edging. if they still dont understand it you can just tell them what you need it for...

Nick Geraedts · Post by **Nick Geraedts** » Thu Feb 26, 2009 10:43 am

Thanks for the replies. I'll see if any of the places/methods here work.

Where to get U-channel tubing?

Where to get U-channel tubing?

Re: Where to get U-channel tubing?