P180 front door replacement.
Posted: Wed Sep 13, 2006 6:24 am
I've had this case since the start of this year. Front door warp had gotten worse over time. I finally decided to get a replacement.
I started by emailing Altech (Australian Antec distro) and asked if they can post it out to me. They refused, so I went to Antec support. They got me into contact with a supervisor and after providing a serial number they sent it out to me and I received it next day, well packaged. Very pleased there.
New door looks hot. Sturdy as hell. But when I put it on I noticed the middle of the door stuck out from the case. It seemed like the new door was kind of incompatible with my older version p180, so to speak. Pics:
Anyone been in a similar situation? I emailed the Altech rep back and he can see what I'm on about just needs to get back to me. It was a bother going out to their Sydney branch which is why I asked for it to be posted. If they are willing to just swap the case for the new revision I'd probably make the drive. I doubt that will happen though.
I started by emailing Altech (Australian Antec distro) and asked if they can post it out to me. They refused, so I went to Antec support. They got me into contact with a supervisor and after providing a serial number they sent it out to me and I received it next day, well packaged. Very pleased there.
New door looks hot. Sturdy as hell. But when I put it on I noticed the middle of the door stuck out from the case. It seemed like the new door was kind of incompatible with my older version p180, so to speak. Pics:
Anyone been in a similar situation? I emailed the Altech rep back and he can see what I'm on about just needs to get back to me. It was a bother going out to their Sydney branch which is why I asked for it to be posted. If they are willing to just swap the case for the new revision I'd probably make the drive. I doubt that will happen though.