Papst 4412 FGL or Enermax UC-12FAB ?

Control: management of fans, temp/rpm monitoring via soft/hardware

Moderators: NeilBlanchard, Ralf Hutter, sthayashi, Lawrence Lee

Post Reply
DG
Posts: 424
Joined: Thu Feb 26, 2004 3:40 pm
Location: EU

Papst 4412 FGL or Enermax UC-12FAB ?

Post by DG » Thu Feb 26, 2004 4:48 pm

I know, i know, not another 120mm fan thread! :D But i've searched the forum and i didn't find an answer to my question...So here it goes:

Wich is the most silent of the two fans, without a FanMate, at:
Papst 4412 FGL .... at 12v
Enermax UC-12FAB ... at the lowest speed setting
?

bomba
Posts: 320
Joined: Fri Jan 16, 2004 12:36 pm
Location: USA

Post by bomba » Fri Feb 27, 2004 8:08 am

That's a strange question, why would you want to compare the noise level of the enermax at min speed to that of the papst at full speed? If this helps, I swapped my stock Sonata case fan for the 4412. Both were powered from the TP380S fan only power connector, which on my system normally sits around 6Vdc. The Papst is much quieter than the stock fan, almost inaudible unless I stick my head under the desk. Definitely recommended. All things equal, a sleeve bearing (aka hydrowave) fan will be quieter than a ball bearing (enermax) fan.
Luddite w/ old-skool P4 desktop rigs, incl. custom home server w/ 8 fanless/trayless hot-swap SATA bays in a mid-tower case w/ single 120mm fan.

Post Reply