SpeedFan 4.39 released

spc · Post by **spc** » Mon Aug 10, 2009 5:05 am

http://www.almico.com/sfdownload.php

4.39 - added full support for Fintek F71889F, even at unusual addresses
- added support for a new method to access SMART data
- added support for SCSI and SAT hard disk SMART access
- added full support for SuperMicro PWS-865-PQ PSU
- added full support for Winbond W83795G
- added full support for SMSC EMC1402
- added SHORT and EXTENDED OFF-LINE SMART TEST in SMART tab. This feature works on a number of supported interfaces and not on all of them
- added voltage readings for Winbond W83793G
- properly read Tjmax on Core i7 based Xeons
- relabeled IT8512F to IT8512E
- the tray hint is no longer updated if ShowStaticIcon is true
- the tray icon tooltip layout is now vertical
- added Fintek F72569DG detection

dhanson865 · Post by **dhanson865** » Mon Aug 10, 2009 8:57 am

Thanks for the heads up. I use speedfan on my primary system at home.

Rebellious · Post by **Rebellious** » Tue Aug 11, 2009 8:59 am

I think Speedfan has been broken for a while.

If I use "software controlled" and then back to "smart guardian", fans stop completely and BIOS (or any other utility) cannot detect them. Happens on both my machines, and only a reboot will get fans working again. Also, it does not detect my AHCI disks, but works if you set them on IDE mode.

dhanson865 · Post by **dhanson865** » Tue Aug 11, 2009 9:27 am

Rebellious wrote:I think Speedfan has been broken for a while.

If I use "software controlled" and then back to "smart guardian", fans stop completely and BIOS (or any other utility) cannot detect them. Happens on both my machines, and only a reboot will get fans working again. Also, it does not detect my AHCI disks, but works if you set them on IDE mode.

Broken for you may be perfectly working for tens of thousands other users. I would love to hear it worked on every computer known to man but for now I'll be happy if it works on 2 out of 3.