Hi,
I have a question about cleaning pots and switches in audio equipment: over time they corrode and cause noise and/or intermittent dropout. My Audible Illusions Modulus 2C had the left channel on the line input sporadically dropping out and causing lots of scratchy noises, and I managed to get it working (better) simply by toggling it on and off multiple times. Is the best method just to spray contact cleaner in the switch, or maybe get some conductive grease on the contacts? I will take a look at it to see if the latter is even possible.
Also, on my office / computer stereo, the Denon receiver has a variable loudness control that is very intermittent, and I already tried to spray clean it a while back. I think this one will require soldering a jumper on each channel to bypass the pot's wiper contacts, and run it "flat" - which is how I prefer it anyway.
Audio System Mods, Repairs & Maintenance
-
- Moderator
- Posts: 7681
- Joined: Mon Dec 09, 2002 7:11 pm
- Location: Maynard, MA, Eaarth
- Contact:
-
- Posts: 166
- Joined: Tue May 27, 2008 12:04 am
- Location: Finland
Re: Audio System Mods, Repairs & Maintenance
Toothpaste or coca-cola are great stuff to remove corrosion both for silver, copper and golden surfaces. (I'm not sure if it works for coal surfaces used on some variable switches in older amps, but worth a try as well). How you might get the paste to the surfaces is up to you, but after you get it there you only need to turn the switch for a few times.NeilBlanchard wrote:I have a question about cleaning pots and switches in audio equipment
After the cleaning you could actually use some grease to protect them from future corrosion. The paste also removes all the existing grease possibly there, so the surface is left "fragile" for oxygen to attack again.NeilBlanchard wrote:...or maybe get some conductive grease on the contacts?
-
- Moderator
- Posts: 7681
- Joined: Mon Dec 09, 2002 7:11 pm
- Location: Maynard, MA, Eaarth
- Contact:
Re: Audio System Mods, Repairs & Maintenance
Thanks for the tips; I appreciate it.
-
- Posts: 5275
- Joined: Wed Jun 13, 2007 10:12 am
- Location: ITALY
Re: Audio System Mods, Repairs & Maintenance
maalitehdas wrote:After the cleaning you could actually use some grease to protect them from future corrosion. The paste also removes all the existing grease possibly there, so the surface is left "fragile" for oxygen to attack again.NeilBlanchard wrote:...or maybe get some conductive grease on the contacts?
I don't know what yo mean for "grease", but oily products can be counter productive on potentiometers.
Re: Audio System Mods, Repairs & Maintenance
I used electronic cleaner spray with great success on the volume pot on my cheap kitchen radio. That stuff is supposed to evaporate. I would hesitate to use something that leaves grease behind.
-
- Posts: 5275
- Joined: Wed Jun 13, 2007 10:12 am
- Location: ITALY
Re: Audio System Mods, Repairs & Maintenance
What about something like this?
Re: Audio System Mods, Repairs & Maintenance
I've always liked the DeoxIT sprays. DeoxIT F-series was designed for faders but works equally well for pots. DeoxIT D-series works well for contacts/switches and is also recommended for use in pots.