Hi,
So I have a new system I have have assembled myself and I have been working to silence .. but I still have a ways to go! I have a Corsair H80i and corsair "silent" fans... but there is still a hum... My guess is that it's the Corsair pump that is the source of the low hum.. I notice that if I merely tilt the PC Mid tower (It's a Fractal Define R4 case) on to two of its feet (instead of sitting on all 4) , the hum almost disappears!!! I think the hum is being amplified by my Desk! Does anyone have any suggestions for a pad or material I could place the PC on that would eliminate that amplification? The alternative is to put it on the floor, but I confess I like having it handy and don't relish the idea of crawling under the desk to access it.
Jeff.
Any suggestions for material to set PC on?
Moderators: NeilBlanchard, Ralf Hutter, sthayashi, Lawrence Lee
-
- *Lifetime Patron*
- Posts: 2269
- Joined: Sun May 21, 2006 9:09 am
- Location: Northern California.
Re: Any suggestions for material to set PC on?
WELCOME TO SPCR!
I use old scraps of neoprene. (its what wetsuits are made of)
theres also a company called "isolate it!", they make many different types of vibration absorbing feet.
I use old scraps of neoprene. (its what wetsuits are made of)
theres also a company called "isolate it!", they make many different types of vibration absorbing feet.
Re: Any suggestions for material to set PC on?
Ah! Neoprene! I actually have a wet suit .. but I think I'll hang on to that!
I'll try to find a sports store ... I live kitty korner to R.E.I.. maybe they might have some scraps lying around! The Isolating feet idea sounds intriguing! Thanks! I'll make inquiries!
Jeff
![Smile :)](./images/smilies/icon_smile.gif)
I'll try to find a sports store ... I live kitty korner to R.E.I.. maybe they might have some scraps lying around! The Isolating feet idea sounds intriguing! Thanks! I'll make inquiries!
Jeff
Re: Any suggestions for material to set PC on?
Weren't a lot of old mouse pads neoprene? You know, the floppy rubber kind with fabric top, where after a few years the fabric adhesive starts to fail?! But you hang on to it because, you're like, "ah - what's the difference? It's not so bad." And as the years go by, the university logo that was printed on the fabric has worn away, which used to remind you that you're not applying yourself. I have some of those...
You might have some laying around. Even if it's not real neoprene, the ones I have a about 1/4" think and are really soft. Cheap material to cut apart for experimenting.
You might have some laying around. Even if it's not real neoprene, the ones I have a about 1/4" think and are really soft. Cheap material to cut apart for experimenting.
Re: Any suggestions for material to set PC on?
Then there is Sorbothane. An expensive material, but one created for vibration damping.
Re: Any suggestions for material to set PC on?
The 280mm radiator fits snugly on the front fan mount, but intake/outlet needs to be at the bottom otherwise you'd need to drill new holes for mounting. Yes, the air from the radiator blows into the case. Yes, the intake is tiny. But it still works. The processor idles at around 38 degrees C and the GPU around 31. Max I have seen is 76/40. This is with the 960 running at 4 GHz with only a minor bump in voltage.