P180 top-hole blanking plate by me, with pictures.
Moderators: NeilBlanchard, Ralf Hutter, sthayashi, Devonavar
P180 top-hole blanking plate by me, with pictures.
I didnt have anything else to do and had some spare .75mm polycarbonate over from my PSU duct so i made a blanking plate for the top hole and painted it black, since its polycarbonate its easy to paint, has a near perfect color match matte finish on the paint side and mirror-like finish on the other side Took me about an hour or so to make, plus painting with polycarbonate spraypaint.
Again i apologize for the image quality, but its hard to get good photos indoors with my phone.
What do you think?
Again i apologize for the image quality, but its hard to get good photos indoors with my phone.
What do you think?
-
- Posts: 192
- Joined: Wed Dec 07, 2005 6:04 am
-
- Posts: 580
- Joined: Sun Aug 11, 2002 3:26 pm
- Location: USA (Phoenix, AZ)
-
- *Lifetime Patron*
- Posts: 288
- Joined: Sat Oct 22, 2005 10:39 am
Thanks for the positive feedback 1mm sheet would be better though, now its just a bit too thin. It would fit even smoother if it was 1mm. The paint i used is black humbrol polyCARbonate paint, meant for RC-cars wich happen to have polycarbonate bodies because its so damn durable.
I might use this one as a template and make another, i have some 1mm sheet too but its a nice 50x50cm untouched piece...
I think im going to the garage and make another, im pissed off at this computer right now. see my thread in General Gallery about the magnificent P150 with a polycarbonate(i love this stuff) PSU duct.
I might use this one as a template and make another, i have some 1mm sheet too but its a nice 50x50cm untouched piece...
I think im going to the garage and make another, im pissed off at this computer right now. see my thread in General Gallery about the magnificent P150 with a polycarbonate(i love this stuff) PSU duct.