I think I got a resonance problem... suggestions?
Moderators: NeilBlanchard, Ralf Hutter, sthayashi, Lawrence Lee
I think I got a resonance problem... suggestions?
The loudest components in my PC, is 3 S-Flex's at approx. 500 rpm. I thought that would be very nice - but it's still noisy.
It sounds crazy, I guess, and I dont understand why it's still annoying...
Problem: With case side panel off, my PC is very quiet. When panel is on, and the PC is under the desk, there's an annoying sound. Sometimes it's like a constant humm, at other times it's more like a woh-woh-woh at a frequence I'd guesstimate to 2-5 times pr. second. The last scenario is the most common - though it depends on where my ears is positioned relative to the PC.
It also depends on how well the room is dampened. Unfortunately my new home office is less dampened - a consequence of being far less messy
The front of the PC is approx. 1 meter from my ears, and it's below my desk.
I dont hear it much, if I listen to quiet music, but when music is off, I can easily hear it during daytime. (I live in a quiet area)
System details:
Antec P180 - fan grills cut, and the front inner doors is removed.
AMD 4850e with Asus Triton 75 bend, so the radiator part is directly in front of the exhaust fan @ the rear.
Seasonic S12 380 modified with a softmounted S-Flex, which never exceeds 500 RPM's.
2 x Hitachi 5K160 2,5", each in a Scythe Quiet Drive, soft mounted with the stock P180 silicone grommets in the lower chamber.
I've done the usual stuff with the P180: Top exhaust closed, all PCI slots closed, vents next to PCI slots and around PSU is also closed. There's a front intake S-Flex, and a ditto rear exhaust. Both softmounted. Cabling aint beautiful, but the air path is clean.
No vibrations can be felt on the case.
The rear of the PC is less than 12 cm from the wall behind it, and I've tried some clothing on the wall, in order to dampening reflections... Didnt work.
I tend to try some kind of dampening material... But I dont want to waste money and time, if it's the wrong way to go.
Oh, the front fan run about 50, maybe 100, RPM slower than the rear - can this cause problems? I tried without the front fan, but then the rear fan got a more grrr-like sound - I dont recall if the woh-woh-woh was there...
I'm a bit confused about what to do, and I'd really appreciate some suggestions
Thanks,
Thomas
It sounds crazy, I guess, and I dont understand why it's still annoying...
Problem: With case side panel off, my PC is very quiet. When panel is on, and the PC is under the desk, there's an annoying sound. Sometimes it's like a constant humm, at other times it's more like a woh-woh-woh at a frequence I'd guesstimate to 2-5 times pr. second. The last scenario is the most common - though it depends on where my ears is positioned relative to the PC.
It also depends on how well the room is dampened. Unfortunately my new home office is less dampened - a consequence of being far less messy
The front of the PC is approx. 1 meter from my ears, and it's below my desk.
I dont hear it much, if I listen to quiet music, but when music is off, I can easily hear it during daytime. (I live in a quiet area)
System details:
Antec P180 - fan grills cut, and the front inner doors is removed.
AMD 4850e with Asus Triton 75 bend, so the radiator part is directly in front of the exhaust fan @ the rear.
Seasonic S12 380 modified with a softmounted S-Flex, which never exceeds 500 RPM's.
2 x Hitachi 5K160 2,5", each in a Scythe Quiet Drive, soft mounted with the stock P180 silicone grommets in the lower chamber.
I've done the usual stuff with the P180: Top exhaust closed, all PCI slots closed, vents next to PCI slots and around PSU is also closed. There's a front intake S-Flex, and a ditto rear exhaust. Both softmounted. Cabling aint beautiful, but the air path is clean.
No vibrations can be felt on the case.
The rear of the PC is less than 12 cm from the wall behind it, and I've tried some clothing on the wall, in order to dampening reflections... Didnt work.
I tend to try some kind of dampening material... But I dont want to waste money and time, if it's the wrong way to go.
Oh, the front fan run about 50, maybe 100, RPM slower than the rear - can this cause problems? I tried without the front fan, but then the rear fan got a more grrr-like sound - I dont recall if the woh-woh-woh was there...
I'm a bit confused about what to do, and I'd really appreciate some suggestions
Thanks,
Thomas
-
- Site Admin
- Posts: 12285
- Joined: Sun Aug 11, 2002 3:26 pm
- Location: Vancouver, BC, Canada
- Contact:
Re: I think I got a resonance problem... suggestions?
Worth trying temporarily, even with some packing open-cell foam. Put some somewhere not touching any components, probably the inside of the cover. See what happens.Thomas wrote:I tend to try some kind of dampening material... But I dont want to waste money and time, if it's the wrong way to go.
This could be an issue -- intermodulation between two close-freuqnecy sounds. But the fans are far apart...Oh, the front fan run about 50, maybe 100, RPM slower than the rear - can this cause problems? I tried without the front fan, but then the rear fan got a more grrr-like sound - I dont recall if the woh-woh-woh was there...
It could also be those drives, even tho they are encased.
This is a situation where you have to get creative to identify the source of the noise first of all. I think you're right that it's some kind of cavity resonance -- in which case, even a small amount of high absorption (dense) foam in the right places could help. But it could also be interaction between noise sources.
-
- Site Admin
- Posts: 12285
- Joined: Sun Aug 11, 2002 3:26 pm
- Location: Vancouver, BC, Canada
- Contact:
open-cell foam -- the spongy foam used for shock damping in shipping cartons. it's open cell -- which allows sound to be absorbed (and water too, in a sponge) -- as opposed to closed cell.
high absorption (dense) foam -- like http://www.silentpcreview.com/AcoustiPack_delux and similar (all of which incorporate open cell foam)
high absorption (dense) foam -- like http://www.silentpcreview.com/AcoustiPack_delux and similar (all of which incorporate open cell foam)
Super, thanks to both of you
Now I have a couple of things to try out - I have fanmate, I could use on the front fan, and see, eh, hear how it interacts with the rearfan at different speeds.
I'm also going to disconnect one of the drives, the one with more platters are the easiest to disconnect, since it aint the system drive.
And I have to check if I have some foam laying around.
Thanks again
Now I have a couple of things to try out - I have fanmate, I could use on the front fan, and see, eh, hear how it interacts with the rearfan at different speeds.
I'm also going to disconnect one of the drives, the one with more platters are the easiest to disconnect, since it aint the system drive.
And I have to check if I have some foam laying around.
Thanks again
-
- Friend of SPCR
- Posts: 38
- Joined: Wed Jul 01, 2009 4:00 pm
- Location: Perth
Sounds like the desk could be amplifying it! I've got the same resonance issues - not loud at all but gets annoying, and made worse when I put the case in the desk computer hole. Mine also comes and goes!! Let me know what you get with the different HDD, fan speed combos!
Going to suspend my drives tomorrow as the sounds changed when I swapped HDD.
(I've got a dampened Sileo, which probably helps although not too silent a case at all!)
Going to suspend my drives tomorrow as the sounds changed when I swapped HDD.
(I've got a dampened Sileo, which probably helps although not too silent a case at all!)
Both S-Flex in the upper chamber are now excluded - I found out I could stop them, while my PC was closed and below the desk - didnt made any change in the sound.
I suspect one of my harddrives is the problem. I vaguely recall, that I used one 80 gig drive for a while, and when I added the second one (160 gig edition) there were more noise. Afterwards I made several other changes to the system and forgot about. I think it's been there for a long time, and after I moved the PC to another room, it's more apparent.
So now I'm down to the noise comes from the lower chamber, which only contains the 2 disks and the PSU. And maybe the location amplifies the noise...
It might take some time, before I have time for further testing, but I'll keep you updated
I suspect one of my harddrives is the problem. I vaguely recall, that I used one 80 gig drive for a while, and when I added the second one (160 gig edition) there were more noise. Afterwards I made several other changes to the system and forgot about. I think it's been there for a long time, and after I moved the PC to another room, it's more apparent.
So now I'm down to the noise comes from the lower chamber, which only contains the 2 disks and the PSU. And maybe the location amplifies the noise...
It might take some time, before I have time for further testing, but I'll keep you updated
Thomas wrote:Both S-Flex in the upper chamber are now excluded - I found out I could stop them, while my PC was closed and below the desk - didnt made any change in the sound.
I suspect one of my harddrives is the problem. I vaguely recall, that I used one 80 gig drive for a while, and when I added the second one (160 gig edition) there were more noise. Afterwards I made several other changes to the system and forgot about. I think it's been there for a long time, and after I moved the PC to another room, it's more apparent.
So now I'm down to the noise comes from the lower chamber, which only contains the 2 disks and the PSU. And maybe the location amplifies the noise...
It might take some time, before I have time for further testing, but I'll keep you updated
I'm glad you found the noise source. Yeah, I've also found some harddrives actually sound like a spinning fan.
I've also concluded that in my setup (P182) the HDD makes more noise if I have it in the lower chamber together with the PSU.
I still have some investigation to donew2spcr wrote:I'm glad you found the noise source. Yeah, I've also found some harddrives actually sound like a spinning fan.
I've also concluded that in my setup (P182) the HDD makes more noise if I have it in the lower chamber together with the PSU.
Your observations about HDD's in the lower chamber are interesting, thanks