psiu wrote:The multiplier is 10x on that chip, so the bus speed must be set at 100. If the CMOS isn't holding onto that, check the battery, it may be dead and resetting everytime.
Also doublecheck that the BIOS is updated and any jumpers on the board are set properly. If the bus speed is set correctly to 166 you will have the proper speed.
They may not have updated the BIOS to properly recognize the Semprons as such--give em a name like Athlon MP instead *shrug*
YAY!
I disabled the BIOS auto-detection of clock and RAM speed, set them both to a nice 166MHz for 1:1, and voila:
+10,000 Clever points for PSIU
Which begs the question: If a Sempron and an MP both have the same Family and Ext. Family data, then would a clocked MP be detected as a Sempron?
And does this mean Semprons are suitable for multiprocessor boards?
![Very Happy :D](./images/smilies/icon_biggrin.gif)