Sidenote : I am very very very novice when it comes to anything with V/I/R/W,A,Ohm... ;p
1)I did install a custom start button some time ago and plugged that into the motherboard , one of following:
http://www.aquatuning.nl/waterkoeling/m ... pin?c=4930
Now it did work before but the LED stopped working so I tested it on a 12V -5A battery which resulted positive in a shining LED. Now I noticed the LED was actually 12V specification from the beginning so hooked it up now to a Molex 12V line and works again.Apparently most front panel motherboard connector only supply 3-5V for LED?
Any reason a 12V led working on 5V before is not working now , weather , led wearing out,...? If I swap the button with a newer one that works still from the motherboard connection.
2) By accident I short circuited either 12V or 5V pins for the button which resulted off course in the power supply shutting down but then it did not boot for a while, I know in a house there safety switches basically jumping into a off position but how does a power supply do it. Because after waiting for a while everything is working again. Could it have dmg any system parts?
Regards Ward.
PS not sure In which forum to post this.
LED electrical question + short circuit question
Moderators: NeilBlanchard, Ralf Hutter, sthayashi, Lawrence Lee, Devonavar